Twenty years my Les Paul has carried this flaw: a neck position that turns muddy, low end that blurs the moment you leave the treble behind. Rather than swap it out, I set out to design the pickup that would fix it — a clear humbucker, running against the grain of the Classic 57. The story of how the Cleartone was born.
Inside the Cleartone — the humbucker that breaks from the Classic 57
In the world of guitar pickups, almost everything has already been tried. When you build your own, the urge to explore is natural — and yet you always come back to what already exists, simply because it works. At the same time, you realize just how strong the dogmas are, almost insurmountable for some — standards established over decades that are hard to break free from, or even to question.
Yet players evolve. The ear changes, preferences too — what sounded perfect yesterday can feel insufficient tomorrow. That may explain the thriving second-hand pickup market, that eternal cycle of buying and selling.
A paradox, in the end: references frozen for decades, in a sonic world in constant motion.
Twenty years ago, I loved my Les Paul — my sound was Gibson. Only the Telecaster occasionally caught my eye, but nothing matched the legendary American slab. Today it's still there in my rack, countless pickups have equipped it — yet the magic doesn't quite work like it used to. Setting aside the weight, it's mostly that glaring lack of articulation in the neck position that lets it down — a real problem for my current setup and expectations.
What could be more beautiful than a fine guitar plugged straight into the amp, a touch of reverb on the clean tone to fill the silence. That small slice of paradise that makes you forget everything — the imperfection of tubes, that breathing analog sound. The pick roams freely, the treble strings ring out effortlessly, but as you move toward the bass strings, the tone closes in, gets congested. And there it is… the mood is broken.
Why this "mud" problem
It's always interesting to see how the two original major manufacturers divided the territory — one claiming clarity, the other warmth. Why seek balance when you can stand out through extremes.
The bright school
Fender / single-coil
- Long scale, higher string tension
- Alder body, maple fretboard
- Telecaster twang, Stratocaster quack
- Sharp attack, present highs
- Definition, articulation
The warm school
Gibson / PAF
- Short scale, medium string tension
- Mahogany body, rosewood fretboard
- Classic 57 jazz tone roundness
- Dense mids, warmth
- Sustain, body
On a Les Paul and Gibson guitars in general, you get a potent combination: short scale, mahogany, and humbuckers. The lower string tension carries less brightness, mahogany has that unfortunate tendency to swallow the highs, and the humbucker is the perfect candidate to warm things up further. The neck position is the cherry on top — farther from the bridge, the string vibrates more freely, its amplitude greater, and the pickup naturally captures more bass there.
In that intense warmth, only the treble strings hold their own — their naturally high frequencies cut through without much effort. For their wound counterparts, it's a different story: they struggle to find air, drowning is never far off.
SOS: Les Paul in distress
If I were a luthier, I'd build a different guitar. If I were an electronics engineer, I'd sculpt the frequencies with filters. But I'm a pickup maker — so let's design a mud-free neck humbucker for this Les Paul!
- Keep the standard humbucker mounting format
- Retain hum-cancelling performance
- Brighten up and restore articulation in the low end
- Tame any aggressive high frequencies
- Maintain a balanced tone across the full spectrum
We're not going to change the Gibson — its character is what it is, and the goal isn't to turn it into something else. Rather, to help compensate for what is, at bottom, just the flip side of its qualities. The advantage of a pickup is that it can be swapped. The woodwork stays intact, the instrument in its essence is untouched — a screwdriver and a few solder joints are all it takes to return to the original version.
When designing a pickup, you need to keep a reference sound in mind — either the one you're trying to reach, or its opposite. The ear has no memory: it takes so little to adapt, and without that anchor, it's very easy to go round in circles.
Always keep a reference sound within reach.
I tested so many pickups on this mission, from budget surprises to high-end handmade models — to name only the best-known: the Bare Knuckle Mule, the Gibson Burstbucker, the Seymour Duncan Slash APH-2, the classic Classic 57, and a whole range of boutique PAF-style pickups. Nothing even began to clear the congestion. I was even tempted to step outside the double-coil format and try P90s in humbucker sizing — those famous P94s — but I wanted to meet the challenge without cheating.
Recipe for a clear, articulate neck humbucker
-
1
Wind, unwind, repeat
After months of trials, rewinding, and trial and error, the Cleartone finally found its form. It wasn't born from a blueprint, but from a long series of back-and-forth between the workbench and the amp. It brings definition and articulation to a position that, too often, dissolves into mud.
-
2
Lighten the magnetic circuit
Inductance is closely tied to the magnetic side of a pickup. In a humbucker, the principle relies on a baseplate magnet — placed underneath — and soft iron pieces that conduct the magnetic field under the strings. The best mud-fighting configuration I found: ditch the slug poles in favor of a second row of screws, and replace all slotted screws with hex screws — less steel, therefore less inductance.
-
3
Set limits
I stopped the descent around 2 henries — already half a PAF. I capped myself in that zone (which is where Strat and Tele pickups live). I figured some inductance still needed to stay in there. Going that low naturally changes the pickup's response: some high frequencies wake up, and can occasionally shimmer or become aggressive. A rebalancing is in order.
-
4
Rebalance the whole
This is the step where you decide whether the pickup deserves to go into production. A pickup can excel in a few areas and still be average — or even poor — overall. One element truly changed the game: the brass baseplate. It naturally filters out aggressive frequencies and helped enormously with overall balance. From there, it was a matter of fine-tuning various parameters — winding wire, magnet strength, output cable type…
Pickup inductance is measured in henries (H). A classic PAF humbucker sits around 4 to 6 H, while a Stratocaster or Telecaster single-coil falls between 2 and 5 H. The higher the inductance, the warmer and more compressed the pickup sounds; the lower it goes, the more clarity and articulation it gains. That's precisely the lever the Cleartone exploits.
A clear neck humbucker — mission accomplished?
- Keep the standard humbucker mounting format
- Retain hum-cancelling performance
- Brighten up and restore articulation in the low end
- Tame any aggressive high frequencies
- Maintain a balanced tone across the full spectrum
Most of the goals have been met, and the neck position on my Les Paul is so much more enjoyable. The low end still lacks a touch of articulation — nothing compared to before — but within a traditional humbucker format, it seems hard to push further on that point. This challenge allowed me to design a humbucker that perfectly fits the Clarity brand identity. And having mounted it on other guitars — SG, Telecaster — it genuinely sounds great.
It's a double-coil that fully retains its humbucker character — the difference plays out mainly in the upper frequencies. All those frequencies now available again counterbalance the often excessive midrange on these instruments. The result is far more balanced, articulate, and defined. The response is much broader — it's a real pleasure to play.
Birth of the Clarity Cleartone Humbucker
Here is the Cleartone, instantly recognizable by its two rows of screws. A more traditional look is entirely achievable (with or without a cover), though I recommend keeping this configuration. Individual adjustment of all 12 pole pieces allows for better balance between the two coils.
Every pickup is wound and assembled by hand, one at a time. No batch production: I build to order, which allows certain parameters to be adjusted based on the guitar and the sound you're after.
Right now, my tests are leading me to lean toward slotted screws. Hex screws have the advantage of further lightening the low end, but can sometimes feel slightly lacking in attack response. These are typical customization parameters: the pickup's identity stays the same, but certain details can be adapted to get the best out of each configuration.
The Cleartone is a pickup designed first and foremost for the neck position, built to deliver richness, detail, and depth on clean tones. It has no pronounced peak like many pickups: it's not designed to be flashy, but rather to offer overall balance. It fits on any guitar. On a Les Paul or SG, it will help open things up and bring back some air; on a Telecaster or Stratocaster, it will bring the warmth and smoothness of a double-coil without sacrificing articulation.
Variety, blues, funk, country… the Cleartone moves from one register to another with ease. Comfortable whether fingerpicked or played with a pick, it responds very well to the nuances of your playing. And what else do we ask of a neck pickup, if not a beautiful enveloping warmth? Breath and definition: that's now what my Les Paul delivers.
Try it for 30 days on your guitar. Not convinced? We'll refund you.